Excavator pin and bushing greasing: intervals and grease choice

By Josh Malczak · Fleet & Construction · Published 2026-11-08

Short answer: Most excavator pins and bushings on the boom, stick and bucket need grease every day, and bucket pins often more than once a day in heavy digging, wet or dusty conditions. Check the operator's manual for the exact intervals. Use an NLGI 2 lithium complex or calcium sulfonate grease, usually with moly (molybdenum disulfide) for these slow, heavily loaded joints, and pump until fresh grease pushes old grease out of the joint.

Why pins and bushings wear out

Bucket and linkage pins carry huge, shock-loaded forces at slow speed, with little or no rotation. That's the hardest condition for an oil film to survive. Grease in these joints does two jobs: it carries the load and keeps dirt and water out by pushing contaminants out of the joint. Skipping a day lets dirt pack in, and that's what turns a pin loose.

Typical intervals

Your operator's manual has the official chart. As a rough guide, many manufacturers call for:

PointTypical interval
Bucket pins and linkageEvery 8–10 hours, more often in mud, water or heavy digging
Stick and boom pinsEvery 8–10 hours or as the manual specifies
Boom foot and cylinder endsDaily to weekly, depending on the model
Swing bearingPer manual, often weekly or every 50–250 hours
Swing gear (open gear)Per manual, often with a specific open-gear grease

New or rebuilt machines, and any machine working in water or slurry, need the shorter end of the range.

Picking the grease

How to grease it right

  1. Clean the fitting before you connect.
  2. Pump until you see fresh grease push old grease out of the joint, not a fixed number of shots.
  3. Grease with the attachment resting on the ground where the manual says to, so the load is off the pin.
  4. Replace broken fittings right away. A dead fitting means a dry pin.
  5. Wipe off the purged grease, which is full of dirt.

Auto-lube systems

Automatic lube systems take the daily greasing off the operator and grease in small, frequent shots, which is ideal for pins. They still need watching: keep the reservoir full with the right grade, check that lines and metering blocks deliver to every point, and switch to a pumpable winter grade before the cold.

Frequently asked questions

How often should I grease excavator pins?
Many manufacturers call for every 8–10 hours on bucket and linkage pins, and more often in severe conditions. Follow your manual.
Is moly grease good for excavators?
Yes, for pins and bushings. Moly helps under shock loads and slow movement. Check the OEM spec for swing bearings and gears.
Can I over-grease excavator pins?
Pins are designed to purge, so extra grease mostly comes out the ends. That's very different from electric motor bearings, where over-greasing causes damage.

Information here is general guidance. Always check your equipment manufacturer's recommendations and warranty terms.

Free download: PA Plant Lubrication Checklist

A one-page walk-through checklist for maintenance teams: storage, contamination, labeling, oil analysis and winter readiness.

Download the checklist (PDF)

Want a second set of eyes on your lubrication?

Tell me what you run and what's giving you trouble. I'll come out, walk the equipment, and give you a straight answer on what would help, whether or not you end up buying anything.

Request a lubrication review Call 724-406-9524